|
Right Angle Worm Gearbox
Dimensional Chart
Adaptable Worm Gearbox
Vertical Worm Gear Box
Horizontal Worm Gearbox
Selection Criterion of Worm Gearbox
Installation and Maintenance of Worm Gearbox
The
AGNEE
Worm Speed Reducers (gearbox) have Cast Iron Gear Case of streamlined design completely
air tight, dust proof and capable of being installed in open without any
cover. The Worm Shaft is made of Alloy Steel, duly hardened, tempered and
ground. The Worm Wheel is made of Chill Cast Phosphorous Bronze and teeth
accurately Generated on Gear Hobbing Machines. They are supported on Extra
Heavy Duty Taper Roller anti friction Bearings of ample margin of safety to
allow adequate journals as well as thrust loads. Lubrication is effected by
splash of oil from the sump. Thus, no special care is required except for
occasional oil topping to the required level. Air cooling is affected by means
of standard polypropylene or metal fans. Apart from
standard range, Gear Boxes are also tailor made to suit individual
requirement or as per specifications provided. They are available in:
|
|
|
·
Vast range of
Models suit every individual's requirement.
Available
Models are:
30, 40, 50, 60, 75, 85
(Adaptable Worm Gearboxes)
75, 100, 125, 150, 175, 200, 250 (Vertical Worm Gearbox)
75, 100, 125, 150, 175, 200,
250, 300, 350, 430 (Horizontal Worm Gearbox)
·
Ratio 30:1 or 40:1 are usually available
Ex-stock or on short notice
·
Center
Distances from 40 mm to 400 mm
·
In Single or
Double Stage Reductions
·
Ratios from
5:1 to 4900:1
·
Also made as
per customer's specifications, Drawing, requirements
·
Overhauling
of Old Gear Boxes also undertaken, Early delivery schedules
<<back |
